Control Modules

CMD-001 Analog Interface Module

Remote control interface enables on-board dimming of lamp via interface with E-Lite Power Supplies.

CMD-002 Manual Dimming Module

A rotary dimmer switch is used to manually dim the lamp.

CMD-004 Variable Flashing Module

Two flush-set screwdriver pots (dials) are used to manually adjust the "On" time and the "Off" time of the flashing lamp.

 

Connections & Terminations

Any of a number of different methods can be used to very simply attach connectors to the lamp. E-Lite makes available ETCO and AMP brand connectors, but many other types are commonly used.

See Connectors and Lamp Termination - ETCO and AMP for more information.

 

Fixtures

Electroluminescent lamp extrusions and fixtures

FLATLITE® is inherently safe with just the standard indoor or outdoor laminate, but if it was punctured or cut, it would be electrically live. In a decorative architecture application, FLATLITE® requires a fixture (extrusion) for proper installation. There are as many ways to create a protective fixture for FLATLITE® as there are uses for the product itself. E-Lite makes the following extrusions available:

Extrusion SKU Lamp Strip Width (illuminated width, not overall lamp with) Extrusion Consists of:
EDT-0025C-5* 1/4" (0.635 cm)

5' (1.52 m) long base

5' (1.52 m) snap over lens
EDT-0075C-5* 3/4" (1.9 cm)

5' (1.52 m) long base

5' (1.52 m) snap over lens
ADT-0050C-10 1/2" (1.27 cm)

8' (2.44 m) long base

8' (2.44 m) slide over lens
ADT-0100C-10 1" (2.54 cm)

8' (2.44 m) long base

8' (2.44 m) slide over lens
ADL-0100C-8-SN 1" (2.54 cm)

8' (2.44 m) long base

8' (2.44 m) snap over lens
ADT-0300C-10 3" (7.62 cm)

8' (2.44 m) long base

8' (2.44 m) slide over lens
ADT-0600C-10 6" (15.24 cm)

8' (2.44 m) long base

8' (2.44 m) slide over lens
* used for egress applications.  Based on Wiremold® 400 and 800 series raceway. Limited stock of 0075C available
made in usaNCEUL
FAQ'S & GLOSSARY